Connect with us

Hi, what are you looking for?

ALIAALIA




Standards News

Seven PLASA Standards in Public Review

PLASA_Standards_LogoSeven PLASA North America standards are currently up for review.

New Standards:

BSR E1.53 – 20xx, Overhead Mounting of Luminaires, Lighting Accessories, and Other Portable Devices: Specification and Practice. The standard covers specifications for the primary and secondary mounting devices for portable stage and studio luminaires and accessories. It also covers these mounting devices for special effects equipment (e.g. fog machines and bubble machines) that are often mounted along with lighting equipment on trusses and rigging system battens. The standard would give guidance on how to properly affix these mounting devices. Comments are due by US COB on January 4, 2016.

BSR E1.51, The Selection, Installation, and Use of Single-Conductor Portable Power Feeder Cable Systems for Use at 600 Volts Nominal or Less for the Distribution of Electrical Energy in the Television, Film, Live Performance, and Event Industries in Canada. E1.51 is intended to offer guidance in accordance with existing applicable standards and regulations in Canada on how to select, install, use, and maintain single-conductor portable feeder cables used to supply power for television, film, live performance, and special events in Canada. Comments are due by US COB on January 4, 2016.

BSR E1.37-5 – 201x, General Purpose Messages for ANSI E1.20, RDM. This document provides additional Get/Set parameter messages (PIDs) for use with the ANSI E1.20 Remote Device Management protocol. Comments are due by US COB on January 5, 2016.

Standards to be reaffirmed:

ANSI E1.3 – 2001 (R201x), Entertainment Technology – Lighting Control Systems – 0 to 10V Analog Control Specification. The standard describes a method of controlling current-sink devices and equipment by means of an analog control voltage in the nominal range from zero to 10 volts positive, with the control signal current sourced from the controller. It is primarily intended for theatrical lighting controllers and controlled devices (e.g., dimmers), but any device could use this control method. The working group proposes to reaffirm the existing standard, which was previously reaffirmed in 2011. Comments are due by US COB on December 28, 2015.

ANSI E1.30-1 – 2010 (R201x), EPI 23. Device Identification Subdevice. This document is part of BSR E1.30, application level equipment interoperability for control of commonly encountered entertainment technology devices using ANSI E1.17. It specifies a templated device for device identification as typically used for remote hardware and software devices. The working group is proposing to reaffirm the 2010 version. Comments are due by US COB on December 28, 2015.

ANSI E1.27-1 – 2006 (R201x), Entertainment Technology-Standard for Portable Control Cables for Use with ANSI E1.11 (DMX512-A) and USITT DMX512/1990 Products. This standard describes the types of portable cable for the transmission of digital data among products which comply with ANSI E1.11, Entertainment Technology – USITT DMX512-A. It covers recommended cable types, connectors, and their internal wiring. The working group is proposing to reaffirm the 2006 version. Comments are due by US COB on January 4, 2016.

Standard to be Withdrawn:

ANSI E1.30-7 – 2009 (W201x), EPI 29, Allocation of Internet Protocol Version 4 Addresses to ACN Hosts. E1.30-7, EPI 29, is a recipe that changes some of the rules for ACN (ANSI E1.17) so that devices with IP addresses not set by DHCP can be used on a network. The standard is being proposed for withdrawal on the grounds that much of the document was based around a protocol not adopted by the market, and that implementation for IP addressing is better dealt with by designers, not through the standardization of any particular method. Comments are due by US COB on December 28, 2015.

For more information, please contact:
Karl G. Ruling, PLASA Technical Standards Manager
630 Ninth Avenue, Suite 609
New York, New York 10036 USA
Phone: 1-212-244-1505
karl.ruling@plasa.org

www.tsp.plasa.org

Source: Lighting & Sound America

Sign up for ALIA Newsletter

* = required field

powered by MailChimp!

Connect With Us

Latest

Employment News

Advertised Vacancy Number: IPS/SS885991 This is a permanent part-time (0.4FTE) position commencing Term 2, 2024 Perth Modern School is seeking a dynamic and motivated...

Support